Mayan Temple Mission

The transmitter requires four values to be set before it can be turned off. Those values are entered by configuring the following controls on the transmitter:
* encryption wheel
* carrier code
* origin name
* destination coordinates

As each control is solved, its corresponding termination code value will appear in a space at the bottom next to the power LED.

Use the alien artifact to help in configuring the encryption wheel. Change the arrangement using the buttons to the right of the wheel.

The artifact can also help you to configure the 8-bit carrier code by toggling the correct sequence of triangles.

You must enter the origin and the destination for the transmission you wish to terminate.

To fill in the name of the origin planet, go to the Planet Database and enter the correct information to pull up the planet. Then click the button to transfer that name to the transmitter panel.

You already know a lot about the planet where the signal is being sent from. You just need to let the system know. Enter the correct number of stars, rank in distance from the sun, type of terrain that defines the type of planet, the proportion of the surface covered by water, and the necessary element for life on that planet.

The destination of the transmission is written using a numeric galactic coordinate system. Go to the Radar panel and hover over the transmission destination to see the galactic coordinates that you need to enter..

The origin planet is Earth. Earth is a rocky terrestrial planet, third from the singular star (the sun), with water covering 75% of its surface, populated by carbon-based lifeforms.

Use the Destination numeric keypad on the transmitter to enter 7438524 with the alien numbers.

The unlock code is 9685